If the TFTP2 program does not work for you, proceed to the command line instructions below and try those. We will go through the GUI installation process first, which is recommended. Typically you will need to restart if it has been in recovery mode for more than three minutes. If the router does not accept the software, you will need to restart the Reset button process. Recovery mode is only enabled for a short amount of time. Unplug the Ethernet cable and start the process again. If 30 seconds to a minute pass and the lights do not cooperate, you may need to try again. You can release the Reset button at this point. Once the router is in the final stage - where the two sets of lights are flashing back and forth, the unit is in TFTP mode. Next, all of the lights will flash on, then turn off. The lights will remain off for about 10 sections - be patient! Next, the lights from left to right will light up in order: Red, Orange, Green, and Green again.įinally, the 1st and 3rd will light, then the 2nd and 4th, over and over.įirst, the two middle lights, One orange and one Green, will light for a few seconds, then go out. Original Ubiquiti light sequenceįirst, the two middle lights - one Orange and one Green - will light for a few seconds, then go out. Your device will go through one of the two light progressions below. There are two possible sequences of lights for Ubiquiti routers. The lights under the triangle will do a special dance, shown below. While keeping the Reset button held down, watch the lights on the front of the unit.While holding the Reset button down, plug in the Ethernet cable, which will power on the router.Take a paper clip with one end bent out, and gently depress the Reset button on the underside of the wireless router, next to where the Ethernet cable plugs in.If your router is already plugged in to power, remove the Ethernet cable from the bottom of the router.To set the router to recovery mode, it must be powered on with the Reset button pressed, until the status lights flash in a special order. Next, the Ubiquiti router must be put in a special mode to load files on to it using TFTP. You can do this in the Control Panel section for network connections, under the Ethernet port settings. Prepare your computer for TFTPįirst, configure your computer's wired connection with the address 192.168.1.254. After this, you will prepare the router for TFTP and then load the software. First download the TFTP2 client and install it on your computer. We recommend the GUI option if you are new to this process. You can either install the Commotion software onto your router with a graphical user interface (GUI) program for TFTP, or by using the command line. The most likely responses are Windows XP, Windows Vista, or Windows 7. If you aren't sure what version of Windows you have, click on the Start Menu and type winver in to the Run menu or the Search box. This guide should work with any version of Microsoft Windows from Windows XP on. Proceed to the installaton instructions for your platform, below: The appropriate Commotion software image from the downloads page.A Ubiquiti router and its Power over Ethernet (PoE) adapter and power cable.To recover a Commotion installation, you will need the following items on-hand: Add another half hour to an hour for the additional setup steps on these pages. This process takes longer than the basic instructions. Please proceed to the section for your operating system below. You will find instructions specific to the operating system you are running on your computer - either Windows, Mac OSX, or Linux. It contains instructions on using a protocol called Trivial File Transfer Protocol (TFTP) to install the software. This document is designed to help you recover the Commotion software if the Install on a Ubiquiti Device instructions did not work, or if your router has malfunctioning software and needs to be installed again or updated.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |